nass magnets pressure regulators are also called pressure regulators with check valves, or air conserving valves. For these valves its valid that the working pressure is only needed in one direction, the reset pressure set of 1 bar, for example, remains constant even with sinking input pressure , when the primary pressure is applied on the thread side, the set pressure comes out of the connection side. If there is primary pressure from the connection side, this pressure comes out at the thread side without change due to the check valve. The pressure regulator can also be set to allow the return stroke to be uncontrolled (installation behind the valve) to, for example, control the forward stroke of a device.
The pressure regulators have a male thread for threading into the cylinder port.
The key features of the pressure regulators are:
the banjo can be female threaded for installing a fitting or a push-to-connect fitting already installed, or compression fitting,
the female thread can be NPT or pipe thread (G),
The pipe threads threads are from G1/8 to G1/2,
the NPT sizes are 1/8”, 1/4”, 3/8”, and 1/2”,
the push-to-connect fittings can accept 4-10mm, 5/32”, 1/4”, or 3/8” tubing,
The compression fittings are available for tubes from 6-10 mm diameter,
Temperature range is -10° C (14° F) to +70° C (158° F) and
operating pressure is 1 bar (15 psi) to 16 bar (232 psi).